Refrigerators and freezers
When a refrigerator runs without cooling, the condenser coils are usually the first stop. In apartments, those coils hide underneath or behind the toe grille, matted with dust and pet hair that force the compressor to overwork. Then the tech listens for the evaporator fan behind the freezer wall, since a failed fan keeps the freezer cold while the fridge side warms up. Heavy frost on the evaporator coil points to the defrost system, so the heater, defrost thermostat and control board each get a continuity check with a multimeter. Repeated clicking with no compressor hum often means the start relay or overload has failed.
Washers
Standing water in a washer usually traces back to the drain path. The tech checks the pump filter for socks, coins and hair ties, then tests the drain pump motor itself. If the machine will not start or spin, the lid switch on a top-loader or the door lock assembly on a front-loader is a common culprit. Heavy banging on spin points to suspension trouble: tired shocks, worn springs or a cracked drum spider.
Dryers
No heat in an electric dryer usually means a blown thermal fuse or a burned-out heating element, and no heat in a gas dryer often means a weak igniter or failed gas valve coils. A drum that sits still suggests a broken belt, while squealing or thumping points to worn drum rollers or the idler pulley. What people tend to miss is that a thermal fuse fails for a reason, and the reason is usually a blocked vent. In high-rises with long shared vent runs, the tech will check airflow at the exhaust before calling the job done.
Dishwashers
Water pooling in the tub starts with a check of the filter and drain hose, then the drain pump. If the unit hums but never fills, the tech tests the water inlet valve and its solenoid. Dishes coming out wet and cold suggest a failed heating element or high-limit thermostat.
Ranges, ovens and cooktops
When a gas oven clicks without lighting, the hot surface igniter has usually weakened and no longer draws enough current to open the safety valve. The tech confirms that with a clamp meter and may check gas pressure at the regulator with a manometer. Electric ovens that heat unevenly often have a split bake or broil element, and an oven that runs hot or cold usually has a drifting temperature sensor tested against the tech sheet resistance chart.
Microwaves
When the light and turntable work but the food stays cold, the magnetron, high-voltage diode or capacitor is a likely suspect. A totally dead microwave often has a blown internal fuse triggered by a bad door switch. Never open a microwave yourself: the high-voltage capacitor can hold a lethal charge long after the unit is unplugged, and a trained tech discharges it safely before touching anything.
